Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Miramar?
Spring repair in Miramar typically costs $180 – $340 for one spring. That’s the estimate we give most homeowners here for a torsion spring swap on a standard single-car door. Because a matched pair usually gets replaced together, most two-spring doors land around $360 – $680 for the set. The written estimate is what you pay, and it’s free.
We’re Miramar Garage Door Repair Pros, and spring work is one of the few repairs we handle in-house rather than sending out. Meet the team on our Miramar Garage Door Repair Pros page. Our technicians have up to 8 years of experience, and they work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems without having to guess which spring you’re dealing with.
Key Takeaways
- One spring: typically $180 – $340.
- A matched pair (what most two-spring doors need): about twice that, roughly $360 – $680.
- Springs should be replaced in pairs. Replacing one and leaving the other leaves you paying for the second callout.
- Same-day service is common once we’ve looked at photos or heard the door on the phone.
- Free estimates. Call (855) 593-6861. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers break down for a typical spring replacement in Miramar this year:
| What it covers | Typical estimated range |
|---|---|
| One torsion spring, replaced | $180 – $340 |
| Matched pair (two-spring door) | About twice the single-spring range: $360 – $680 |
| Springs plus cable repair (if a cable has failed too) | Cable work adds $130 – $250 |
| Springs plus track realignment | Track work adds $120 – $240 |
| Roller replacement if the wheels are worn | $110 – $220 |
| Opener that’s also failing (unrelated to the spring) | Opener repair $120 – $320 |
What pushes a spring job up? Door weight and door size mostly. A wide two-car door with a heavier panel load uses thicker wire, and thicker springs cost more. High-lift or extended-travel setups take a longer spring and a different torsion bar. If your door has two springs and only one broke, you’re usually better off doing both at once. What keeps a job low? A standard 7-foot single-car door with a clean torsion setup and nothing else failing alongside. That’s the majority of what we see in Miramar’s townhouse and single-family stock.
What Affects Spring Replacement Pricing in Miramar
Miramar homes sit in a fairly tight range as far as garage doors go, but a few local realities move the estimate up or down:
- Door size and weight. Most Miramar garages are one or two-car. A two-car door with double springs is worth more than a single-spring door, which is why the pair range matters.
- Spring type. Torsion springs (mounted on the bar above the door) versus extension springs (running along the tracks on either side). Torsion is the standard on most newer Miramar builds; older doors sometimes came with extension springs, and replacing those is a different job.
- Whether only one spring broke. A pair is usually replaced together even when one snaps. We’ll always tell you when the second spring has enough life left that a single replacement makes sense, and we’ll tell you when it doesn’t. We don’t pad the estimate to make a sale.
- Condition of the cables and drums. When a spring breaks, the cables take the hit. If they’ve stretched or frayed, you’re adding cable repair to the visit.
- Access and door position. A door stuck partway down after a spring failure can take longer to stabilize safely. That affects labor.
- Brand and panel type. Doors from LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor use different spring capacities for the same door size. We carry specs for each so the new spring actually matches your door’s weight.
How to Save on Spring Replacement
Springs are a fixed part cost. You can shave labor and callouts instead:
- Replace the pair at the same time. Doing both springs in one visit means paying labor once. If you swap one and it holds, the second spring usually breaks within a similar window because both have gone through the same cycles. Doing them together usually costs less than two separate visits.
- Deal with secondary wear at the same visit. If your rollers are worn or a cable is fraying, sorting it now avoids a second trip later. A $110 – $220 roller replacement alongside the spring is less than two separate calls.
- Ask about the opener too. If the door has been working harder because the spring was weak, the opener has taken extra strain. Opener repair runs $120 – $320. Cheaper to look now than after the motor gives out.
- Get the free estimate in writing before work starts. Our estimate is free and the written number is the price. Call (855) 593-6861 and we’ll talk through the door before we come out.
- Don’t wait for the second spring. A door running on one spring wears cables and drums faster. Replacing a single spring when both are tired often leads to a second repair within months, which is the opposite of saving money.
For more on what we do and how the process works, read our guide on spring replacement. For a general walk through the full repair range, our garage door repair pricing guide breaks down the rest of the work.
How Spring Replacement Works, and Why We Handle It In-House
Torsion springs are wound to high tension. They store enough force to lift your entire door. When one fails, the door drops and the spring unwinds suddenly. That is why spring repair is one of the few jobs in this trade where trained hands and proper tooling are not optional, and why we keep it in-house rather than handing it to a general handyman or a sub.
Here’s what a spring replacement visit looks like with us:
- Diagnose first. We check the door’s balance, the drum and cable condition, and the spring size against the door weight. No two doors want the same spring.
- Wind the door to a safe position. With a broken spring, the door may be sitting heavy or jammed. We secure it before we touch anything.
- Replace the springs. Matched weight, correct wind direction, correct cycle rating for your door.
- Balance and test. We lift the door by hand, run the opener through a full open-close-open cycle, check the safety reverse, and confirm the door holds without strain.
- Leave you the written estimate, before and after. The price on paper is the price you pay.
A Safety Note on Garage Door Springs
Please don’t try to wind, cut, or remove a loaded torsion spring yourself. The stored energy in a wound spring can cause serious injury, and a slipped winding bar can do real damage. Springs are under enough tension to lift a full-sized door, and when they release unexpectedly they release hard. Call us, or another licensed local pro, before you touch the spring system.
The local professionals we connect you with are licensed and insured as Florida requires. We recommend confirming that with anyone you hire, including us.
Repair or Replace? When Springs Are the Whole Story, and When They Aren’t
In most Miramar cases, spring replacement is the correct fix. The door itself is fine. The panel is fine. The opener is fine. Only the spring has reached the end of its cycle life. That’s a repair, not a replacement.
Replacement starts to make sense when the door as a whole is failing: multiple panels are damaged, the tracks are bent beyond realignment, or the opener is showing terminal problems (bad logic board, dead motor) on a door that’s also due for springs. If your door is old and worn throughout, a new door installation runs $700 – $2200 in Miramar depending on size, insulation, and panel style. We’ll give you the honest read on which one fits your situation. We diagnose first, then recommend.
A few local realities on the “replace” side: Miramar’s summers are hot and humid, and a door sitting in direct sun on a west-facing wall takes a lot of thermal cycling. That accelerates wear on the springs and on the door panels themselves. If both are showing age at once, replacement can be the better spend. If only the spring is gone, replace the spring.
Same-Day Spring Replacement in Miramar
A broken spring leaves you with a door that won’t open, or one you can’t close safely. That’s a job we can usually get to the same day. Call (855) 593-6861. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Same-day work is not priced higher than a scheduled job. The estimate is the estimate.
What helps us quote accurately on the phone:
- The door type (single-car or double-car).
- Whether the door has one spring (torsion on the bar) or two springs.
- The door’s approximate age, if you know it.
- Whether the door is fully closed, fully open, or stuck mid-travel.
- The brand name on the door or opener if you can see one (LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, Raynor).
What Brands Do We Service?
We work on the brand you already have. Our service covers eight of the major systems homeowners in Miramar actually own: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That span matters for springs because spring tension is set by the specific door and opener system, not by a universal part. If you’ve got an older Craftsman or a Clopay door that came with the house, we’ll have the specs. If yours is a Wayne Dalton or Amarr installation, same story.
Our opener work covers the smart-home-friendly brands too (LiftMaster, Chamberlain, Genie, Craftsman). Same team, same callout. One call resolves the whole system. If you need opener work done at the same time as the spring, we’ll quote it together.
Do You Offer Free Estimates in Miramar?
Yes. Every estimate is free, and the written estimate sets the price. Call (855) 593-6861. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Tell us what the door is doing and we’ll tell you what we think it will cost, before we come out.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Miramar?
One spring typically runs $180 – $340 in Miramar. Most two-spring doors land around $360 – $680 because matched pairs are replaced together. Call (855) 593-6861 for an exact quote on your door. Estimates are free.
Is it cheaper to repair or replace a garage door spring?
Repair is almost always cheaper. A spring replacement runs $180 – $340 for one spring or about twice that for a pair, while a full door installation runs $700 – $2200. Replacement makes sense only when the door itself is failing at the same time. Call (855) 593-6861 and we’ll give you an honest read. Estimates are free.
Do I need to replace both springs if only one breaks?
Yes, in most cases. A matched pair (about $360 – $680 in Miramar) is standard because both springs wear at the same rate. Doing one spring at a time costs more in the long run once labor is counted twice. Call (855) 593-6861 to talk through your door. Estimates are free.
How long does spring replacement take?
A typical spring replacement takes one to two hours for a single door. A pair on a standard two-car door lands in the same window. If we’re also doing cables, tracks, or opener work at the same visit, add time for the extra scope. Call (855) 593-6861 for exact timing on your specific door.
Can you replace a garage door spring the same day in Miramar?
Yes, same-day service is usually possible. Call (855) 593-6861. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Same-day work is priced the same as a scheduled visit, and the written estimate is the price you pay.
What else might need fixing along with the spring?
Most spring visits involve only the springs. When other parts are worn, common additions in Miramar run: cable repair $130 – $250, track realignment $120 – $240, roller replacement $110 – $220, opener repair $120 – $320. The full garage door repair range is $150 – $600 if several things are failing at once. Call (855) 593-6861 for a written estimate before we start.
Contact Miramar Garage Door Repair Pros
Call (855) 593-6861 for a free estimate on spring replacement in Miramar. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Tell us what the door is doing and we’ll give you a straightforward number on paper before any work starts. If the spring broke today, we can usually have it open and tested the same day.
Pricing reflects the Miramar market as of 2026. Miramar Garage Door Repair Pros offers free estimates – call (855) 593-6861.
Written by the team at Miramar Garage Door Repair Pros.
What Our Customers Say
"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Eduardo Garcia"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Dana Pruitt"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Aisha Ingram